Counting matching models…
I am working on a gearbox for 3v hobby motors, and needed a model of those motors to design around so I made this one. I worked with the drawing from here , which is partial and may not represent all variants of all manufacturers. I did…
EDIT: If you download and don't post a make, shame on you. UPDATE: A new version - v10 - is now available. Printed it in PLA, looks good. Changelog: Bottom filleted (to prevent loss of digits!!! :)), as suggested by maker. Cover knurled…
Same Idea as regular wind chimes, only in spiral conical shapes.
UPDATE: Added a fused model to print the whole sifter in one go. UPDATE: I had an error in the place of the bolt holes in the bucket, which I thought I fixed, and found out now that I didn't. It is fixed now and the bad model was replaced…
v2: Added a pin for breaking the seal off of a new bucket and improved the internal slits. Someone asked for a bucket-opener on a FB group I am in, and since this will be very usefull for me also, I gave it a go. The model has 3x5 embeded…
This is a planter stylized as an ancient pot or jug, with a high capacity basin to prevent water spilage when watering. I made the design for my aunt Inna's 85'th birthday, hence the name of the model. Unfortunately I didn't take a…
You'll get the hang of it.
IMPORTANT!!! Hinge shafts MUST be printed on the side, such that layer lines will end up crossing from the external part of the hinge to the internal part of the hinge, or in other words - each layer must have one side that is close to…
Print both parts (flat side on bed, no supports - built-in supports in the model. Preferable material - PLA). Put tp roll inside and close them - just press until clicks. Close with holes aligned to use the tp, close with holes on…
Since many printed it with PETG successfuly, ASA is definitely not needed here. Yet I have a lot of it and I want to practice printing dimentionally accurate parts with it, which is not a no-brainer. I've been developing a specialized…
v1: Remodeled the clip halvs to have pin holes for better alignment. This has been printed and used. Pins should fit without much force, if not - let me know and I will update the model. Scaling the pins down a bit may solve the issue for…
This jig is designed to both center the MGN7 linear rail vertically (on one side) of the metal extrusion it is attached to (Voron 0.2) and offset it 33/38 mm from the end of the extrusion end (for z/y rails). Use the 33 mm version to…
I ordered 3 Voron 0.2 kits from Siboor. After assembling the first I realized I really don't like inhaling all those styrene fumes when heat-inserting heat-inserts, so I desided to try to do the next two with no heat-inserts. After all, I…
These are all currently available results.
