Counting matching models…
Designed this case to protect the contacts on the bottom of a ratgdo v2. One model is just the case. You could use zip ties to mount if you want as the original design calls for. The holes are also sized for M4x10mm bolts and the bottom…
Basic stand for a Minisforum MS-01 to allow 6mm of clearance underneath for better airflow to the NVMe drives. In my personal testing with all three drives loaded, I got a 4-5c reduction in temperature.
This mount is designed to be used either with Underware, or multiboard, to mount your Unifi Flex Mini 2.5G Switch.
Even though it goes against the entire design philosophy of the Underware organization system, sometimes a cable tie is still the right tool for the job. This takes up one slot on the multiboard and provides a set of loops to run a cable…
A support designed for the rear GPU finger in a Meshlicious case. Gives more surface area to support the bracket from bending. This is meant to be used when the GPU is in the higher position and in 4-slot mode. Currently this design is…
Enclosure to hold a 100kg flat load cell. This enclosure provides the actuation point for the load cell. This is designed with a lip to be placed under a bed foot or similar. This was designed specifically for the uxcell 100kg…
This stand will hold a single slot PCI-e card. I'm using it to hold an HBA expander, but it could be used with any card. I uploaded a second design without the rear PCI finger holder if you're using in a case at the right height to look…
Designed this fan shroud to cool the commonly available Intel x550-t2 NIC cards that can be found on the second hand market. Needed it to remain 1-slot in width. The fan model that I used is YY7015M12B. This fan is taller than a half…
This is the 3D model for a PCB I designed to connect a D1 Mini and an HX711 together with 4 load cells to create a scale or occupancy sensor. Case is designed to use a single m4x10 bolt and m4 nut. There are no traces that go to the hole…
This mount is designed to be used either with Underware, or multiboard, to mount your Unifi 1G Switch.
This is a work in progress. Currently the bottom middle screw hole is slightly too low to lineup correctly. Also, the bottom holes are a touch too small for the heat set inserts. This is my first design. Uploading it as a request. I…
This is a topper mount to place a Home Assistant Voice PE on top of an original Sonos Play:1. This is the model without the built-in microphone. This was printed in its default orientation with regular supports set to snug. I've printed…
This is a vertical topper mount to place a Home Assistant Voice PE on top of an original Sonos Play:1. This is the model without the built-in microphone. The vertical mount was very quickly just “bolted on” to my original design. It's…
Remixed original design to add space for four magnets in the rear for mounting on metal objects. The stl uses 10mm x 2mm magnets. Fusion 3D file added as well. Can change the diameter and depth of the magnet used in user parameters if you…
This is a top plate to go along with the excellent Anker USB hub mount by davedarko found here: I used M3x16 countersunk screws and m3 nuts. The nuts fit right into the recessed holes so they don't bang up against the underware mounting…
These are all currently available results.
![[WIP] Meshlicious GPU Back Brace](https://media.printables.com/media/prints/138918/images/1320390_9b2b4c91-97e4-44ca-8e61-ce825eaca75a/20211222_140227.jpg)
