Counting matching models…
Print one or more of these interlocking stands, and then stack your cans on them. If you attach, or place upon, a non-slip surface then you can also stack cans up against the wall behind and get more per layer – rather than being limited…
Make your own DWV9470-XJ ! Print this, and then add your own hose and air-lock hose adapters . Print with the single port on the print bed, and the two arms of the “Y” facing up. Would be best to add brim for extra bed adhesion. Can be…
Print three or four of the model of your choice, to support the plant pot. No special settings, infill of around 20% is more than strong enough. The “Corner” variant will probably need supports. I've used PLA to print mine, and they're…
Not much use on its own, but this can be added to your own design to allow the connection of a DeWalt airlock connector. This is basically half of a DWV9130-XJ , the mating part is the DWV9000-XJ . Please share your remixes, so I can see…
Allows you to use a standard garden hose to drain water from your Daikin AC outdoor unit. Designed for the RZQ125KCV4A model, but will likely fit others as well. Print with a sturdy filament if you can, otherwise it can be a bit delicate.…
Made to suit the shape of the older QP6510 Oneblade model, not likely work on the current model as the foot of the shaver is designed to lock into the base. No special settings or supports required.
Not much use on its own, but this can be added to your own design to allow the connection of a DeWalt vacuum hose. Fits DWV9315-XJ , and probably also DWV9316-XJ . Please share your remixes, so I can see what you've done with it!
Keep your quick-change hex-shank screwdriver bits tidy!
The display is at a fairly steep angle to allow clearance behind, in case you've relocated your print bed. The back of the display's IDC socket (i.e: not allowing for the IDC cable) is only 20mm inside the frame. Extra parts required: Two…
This will snugly fit this 0.3-8mm keyless drill chuck on Aliexpress . If you find it is a tight fit you could either print slightly larger or lightly run a file/sandpaper over the faces on the shaft of the chuck. Modifications from the…
This bracket suits at least the Australia/New Zealand version of the Allocacoc Power Cube . Place your cube on this, and quarter-turn to lock into place.
A simple little hook, to hang small things from in your cupboards. Designed for a 5mm hole. If your cabinetry uses a different size, then you can scale this model to suit.
Note: This mod involves mains power wiring and opening the PSU, and will likely require a licensed electrician to do so legally in your country. It is your responsibility to check your local requirements, and undertake this project…
This is very specific to the Joseph Joseph Extend dish drainer. Provides a place to put the sink plug when not in use.
Advance warning This is a bit fiddly, as I got it working to my satisfaction but haven't really finessed it to be easy for someone else to get going. That said, if you have a little electronics and tinkering skills, it should be OK. Any…
Due to issues with my filament and printer setup, I was unable to print the threaded spindle with sufficient accuracy or strength. The skateboard bearing was a very tight press-fit into the pulley, so I was able to get away with this…
Replacement loop for the end of an extendable washing line, to go over the hook in the wall. Made to match my unknown brand washing line, but likely to be suitable for others as well. I've found with PLA in the sun, it does tend to…
Will fit over a handle with a rectangular profile, up to 9.5mm thick. Designed for the gas disconnect I have , but will hopefully work with others.
These are all currently available results.
