Counting matching models…
A simple hook for hanging your headphones in the computer monitor. It suits a headphone band thats max 50mm wide. Attach to monitor with two pieces double-sided adhesive tape. Sand down the sharp edges on the top so it doesnt damage the…
Fits 19mm wide and 150cm long measure tape.
I draw this speaker front since someone asked for something similar for his car. It measures 150x150x5mm. Print Settings Printer Brand: Creality Printer: Ender 3 Rafts: No Supports: No Resolution: 200 Infill: 50 Filament: Esun PETG Black…
Print the cube with 0.2mm layer height, 2 perimeters and extrusion width 0.4mm. Measure all 4 walls, add up these and divide by 4. This is the measured wall thickness. New flow rate = (0.8 / measured wall thickness) * Current flowrate
Didnt find a neat XT60/capacitor holder that suited my demands so i designed my own. It holds a 25V 1000uF capacitor that measure 10mm in diameter and around 17mm long. The legs folds down in channels for insulation. Just add some hest…
I wanted an easier and better way to mount my phone to my Mavic Minis controller so i made this. The GoPro mount for the controller is simply pushed in place. It has holes for a cord so you can make a loop to pull it out of the controller…
Som assortment boxes.. 1x1 measure 55x55mm at the top, 50x50mm at the bottom, the box is 75mm high. Print Settings Printer Brand: Creality Printer: Ender 3 Pro Rafts: No Supports: No Resolution: 0.25 Infill: 100% Filament: ESUN PLA+ Grey…
During rehab after breaking my neck i workout with these colorful rubber bands. In some exercises the rubber band cuts into my hands so i made this handle for a nicer experience. Just thread the band through the handle and fix the band…
I wanted a simple and short stickend to my X-lite so i designed this. It only raise 2mm over the threaded shaft and has a little bowl at the top. The diameter is 10mm. I printed this in TPU to get a good grip, i can press it down the…
I printed this at 0.1 mm layer height, 100% infill and without support.
A remix of Dave_C_FPVs Gathunter Crazybee, instead of a diagonal measure of 115mm this one is only 90mm. I also added slots for battery strap. Thank you Dave for a great design! Category: R/C Vehicles
These are all currently available results.
