Counting matching models…
Half of this jig goes into a small bench vise for holding the mandrel (SpringWinder-Vise-Base_dBottom), the other half goes over the top to use as the winding crank (SpringWinder-Vise-HandleBase-dOuter). Both sides use an insert…
This is a basic 4 way hat switch intended to be used with custom controllers, while working around the limitations of small scale prints on FDM printers. I've printed all of mine in PETG but there's no reason PLA or ABS shouldn't work. 4x…
This is a printed power feed based on a LS400 Front Right (Passenger) window lift motor, P/N 8572050060 (~$15 when I purchased mine) with a generic ‘10-55V DC Motor controller’ (https://www.ebay.com/itm/124828416816). It works with the…
This is a telescoping way cover for the Z axis of the tilt-column Sieg X2 derived mini mill family. It should work on the solid column versions, but I don't have one so I can't test it. The lowest/smallest cover anchors to the screws that…
This is a cap style point model for use with OpenTrack, FreeTrack, or FaceTrackNoIR. It is designed for external power, either via USB or a battery pack. Check out the Serial Build guide on the FreeTrack forums here:…
This is a small model to relocate the SMA connector (without modifying the case) for the most recent model of the OrangeRX DSMX JR module (with the screws on the back/bottom) from coming straight out, up 90 degrees. Make sure you print…
These are all currently available results.
