12 models
Very loud whistle!! Print in place. I wouldn't recommend PLA if it will sit in a hot car. This should work right off the printer, if not you can use needle files to sharpen the blade that splits the air to make it louder.
Print in place, Very loud dual tone whistle. Should work off the print bed. If it doesn't then use a needle file to sharpen the air splitter blades to a clean sharp edge. This should improve tone and increase the decibels. I recommend…
Great little ducted fan unit I made for an RC project. It is made for a Brushed 8520 motor. On the back of the motor aft core cover, drill a small 1/8" hole for the wires to pass through. I recommend using a 0.2mm nozzle for this print at…
Klipper AIO Console For SKR3EZ ****10.11.2023 Updated Bracket For TFT50 and Corrected the Orientation, Please Re-Download**** ****10.13.2023 Updated Bezel and front shell (Added notch for TFT50's ribbon cable)**** ****10.30.2023 Updated…
A very small round whistle I came up with that works great on a zipper or a keychain. No PLA if it will experience high heat like in a car. Scale larger for deeper sound and ease of printing if needed. Using a needle file on the air…
Print both pieces laying flat and material of choice, except TPU, probably wouldn't work that well. Glue both halves together and it's ready to fly! Will need to be “tuned” with blue tack/ sticky tack or similar. Place 0.50-1.0 gram…
This air scrubber can handle it all. High flow dual stage carbon filter and two stage merv13-16 filtration. Air passes through 4 total stages of filtration for cleaner air!! The front of the unit uses 1 carbon filter with merv16 backing…
0.4mm Nozzle Vase Mode RACE!!
Makes the printer very rigid!! I found that a small amount of vibration finds it's way along the y-axis and this was my of eliminating it. The way the ender's are built the middle extrusion almost acts like a pivot point to a small…
Quick design I did for holding my soldering spools. I printed mine out of PLA with 3 parameters and it has been holding up great. When printing the 4x cross brace rods and the main spool holder axle I suggest using a brim of 3-5mm. Will…
L Shaped component, make sure it is printed on its side, so the layer lines follow the length. Other parts just need to be placed on their flattest face. I recommend ABS, ASA or other carbon fiber/glass fiber filled filaments that don't…
These are all currently available results.
