Counting matching models…
Smaller side panel/camera mount replacement for the iFlight Nazgul Evoque F5. The stock side panels crack very easily, but this is very durable if printed in TPU. This also improves airflow to the electronics. The third photo is the stock…
I got an RC car for free, but the chassis support was broken. I had initially printed the file this was remixed from and drilled holes in it, but it broke again and I wanted to fix it better. I moved the holes, removed the lip from the…
Antenna mount for ELRS 2.4 GHz diversity antennas. This should be mounted vertically, with one antenna perpendicular to the ground and the other parallel, to maximize coverage for a ground vehicle. The perpendicular orientation of the…
I used 2 40a 4s escs with 2 5 inch fpv drone motors for power, along with a small servo for steering and a pwm reciever. The skirt is made from a trash bag and attached with duct tape, and it needs weight on the back to balance out the…
This couples a 150 kg/cm servo with an electric trolling motor shaft(30mm). Print with solid walls in PETG or stronger.
Vibration dampener for jetski trailers or similar with “slipper spring” style open ended leaf springs. This is for trailers with a very low load compared to their rating, causing the springs to compress very little over normal bumps.…
These are vibration reduction feet for 12v 32ah LiFePo4 batteries from Battery Hookup. Print in tpu with only one wall and very low infil to allow the feet to flex. These should be glued to the battery to prevent them from coming off. The…
These are all currently available results.
