Counting matching models…
Cookie cutter made in the shape of a husky illustration. 3 Versions available with varying indents, depending what you want to go for. Notes: Printed it in PETG with high layer height to get it done fast, should work for all layer heights…
**Update 04/07/2024** -Pattern updated to match with the hex orientation on the V0 display and skirts so that if anyone is obsessive as I am, their toolhead and V0 display and skirt hexes will now match up (I just didn't notice in the…
Little BTT mini 12864 display case to be able to mount it onto the RatRig V-minion 3D printer or any other (currently) 3030 extrusion frame. STEP files included in case you want to make some alterations. Parts needed: BTT mini 12864…
Little cable clip to route wires along the makerbeamXL extrusions on printers such as the voron v0. Works as supplied even if it may seem that it's a bit small, just be a bit more confident forcing it into the extrusion. STEP included in…
Replacement part for a Mercedes sprinter van seat adjuster. You may want to scale it depending on your tolerances. Probably want to print it in PETG at least to have it survive in a hot car. Step file included if you want to make any…
Small handle to help lifting the lid of the Anycubic wash and cure station. Can be attached with a glue/epoxy if you don't want to drill holes in the cover, with a M4 screw and threaded brass insert, or an M5 fastener straight into the…
I've been using some crap 120mm filters that I stuck together with duct tape for my Corsair H100 240mm radiator before I realized that I have a 3D printer big enough for such a print. The design should fit onto any 240mm radiator and is…
A little enclosure for the BTT CEB. It‘s mountable to wherever you might need it to be with a little VHB or other double sided tape. You will need: x5 M3x8 BHS. x5 M3x5x4 heat set inserts. little bit of VHB or double sided tape. Zip ties…
Lower profile single screw version of @RomRiders reverse bowden holder. Requires: x1 M6x12 screw x1 M6 3030 T-nut a bowden tube coupler of either M6, M8 or M10 thread. I printed it with 0.24mm layers, 2 perimeters and 13% gyroid infill.
Little lever adapter for the La Pavoni Europiccola espresso machine that slips over the existing steam knob. Idea was to not have to fully remove the C clip to replace with a different knob/lever and just slip it over the top of the…
This is a Baratza/Mahlkonig Vario/Forte mod on the single dose hopper. I have attempted to fix the issue where the tolerance of the mating area of the hopper and upper burr carrier would result in chaff blowing back into the grinder. The…
Remix of the bottom_mount_clip that clips into the MakerBeamXL extrusions (such as used by Siboor kits) much easier. I found that the original one from Maple Leaf Makers needed a lot of post processing to get to clip into the MakerBeamXL…
Original model was designed to print upright resulting in it needing supports, and the layer lines ran perpendicular to the primary load direction, making the part susceptible failure under weight. This remix prints flat, aligning the…
This is a replacement top grill for the Fractal Design Node 202. This mod allows you to mount 3 Noctua NF-A4x20 (or any 40mm) fans onto the top grill to help exhaust hot air from the motherboard area. I have no idea yet how it affect…
These are all currently available results.
