Counting matching models…
Remix of Hornet's head from WalRit's Hollow Knight & Hornet. To make a wearable mask, I did the following: increased the size of the head hollowed out the interior cut out the back cut out eyeholes Significant slicing necessary to print…
A simple 75 x 75 mm square with a 0.3 mm height. Intended to be used to calibrate for the Prusa 0.8 mm nozzle profile, which has a 0.3 mm first layer height. Print Settings Printer Brand: Prusa Printer: I3 MK3S Rafts: No Supports: No…
Center strain reliever for a 450 Ohm fed doublet antenna. The wire dimension has been optimized for a snug fit of Davis RF PolyStealth #18 wire. The window is to prevent water from from pooling around the solder connections. Screws are 12…
Minimalist case that fits the qrp-labs QLG2 GPS board with top-mounted antenna. View port for 3 status LEDs. +5 V and TXD cables are held with a pinch that can be tightened using a zip tie. I printed it with PLA, 0.2 layer height. 30%…
The upper and lower frames for the original Air purifier (BlueAir 411 filter) by madewhatnow are difficult to print because of the long, steep overhangs and long bridges at the top. This remix reduces the overhang to about 40 degrees and…
I love the big einsy case, but wanted to secure the extruder cable more securely. I used blender to add 3 slots to the big extruder cable port, so that a zip tie can be used on the extruder cable.
These are all currently available results.
