Counting matching models…
This is a very simple emergency low-pressure water ball valve that can be printed quickly in place (print-in-place) and with no assembly. ver. 1 with 0,3 mm tolerances (in optimization, with comments…) Should be printed using mechanically…
Now You can have a Halloween accident when a nail pierces through your finger (hand,....). Add a bit of gauze (flaster), colour and you are ready to go. Print is fast with no suports.
This is a paper plane launcher - optimized version (v2): widened rail to accommodate paper airplanes better shortened rail-release gap to avoid excessive paper crumpling at the plane tail (empennage) added a tab at the front to hold the…
This is a Roomba robot vacuum cleaner rotating brush or bristle holder for i3/i5 series. v1.1. p.s. For bristles, You can recycle old print skirts (or extrude some material). Cut to length, put in a bristle holder arm, and melt the…
This is a drawer handle that can be relocated to the top (shallow or deep back) or the side of the drawer (no back). It can be printed fast (0.2 mm) with no supports. Print facing up as on the photo. Two sizes are available (7 and 14 cm)…
This is an emergency ring. Sometimes, a hacker/maker needs a ring in a hurry :) The rings are simple, comfortable ellipsoid designs in 3 thicknesses (thin - 3.5 mm, medium - 4.9 mm, and thick - 7 mm) with 11 sizes each. The inner ring…
This is an emergency wedding bridal garter. Use a beautiful ribbon with the print. (you can also print two prints and use two ribbons). Spice it up… ;) Works well in PLA (the design is thin and therefore flexible enough), but would be…
These are corner brackets to join and fix in place 2 TROFAST cabinets for the safety of the children. (do not forget to fix to the wall on the top of the assembly). p.s. prints in white PLA work wonderfully. Prints in place, no supports.
This is a wide neck Erlenmeyer flask inspired design (full model) intended for spiral vase mode. It can be used as a decorative element, pencil holder, flower vase, etc. etc. Your imagination is the limit. p.s. Print on the images was…
These are snap-fit information (or comic) icon buttons for Your IKEA SKÅDIS pegboard. They are printed well in lying (more supports but easier to remove) or upright positions (fewer supports, a bit more difficult to remove) and PLA…
Print as many as You like and make something beautiful. Good Luck! maybe start with 10 small and 10 large “triangles“, later you somehow end up with lots of them ;) (simple as pie)
This is a collection of models and a *.gcode file for Prusa MINI+ printer to transform the Prusa MINI+ into a Zen gardener. print the Zen garden tool (it is a 7mm bit compatible elongated tool that fits on your Prusa MINI+ nozzle) print…
A little holder for 4 Falcon tubes 50 mL for IKEA Skadis system. Supports under Skadis hooks, and that's it.
Sunshade (window shutters) crank holder bracket, however, this is also s general bracket/holder for a stick of approx 16mm in diameter.
This is a very simple but robust frost scraping/removing tool (ideal for car windshields). On one side, the angle is modest to maintain durability; on the other side, it is a sharp tool for difficult corners. The model is large (use…
Bracket for fixing window shutter guide ropes to the window frame. (emphasized by the red circle in the photo of window shutters)
These are all currently available results.
