Counting matching models…
You'll need to mirror one of the STLs in your slicer since the door clips are mirrored. You'll also need to scrape the rest of the broken upper clip out of the door to make room. This fits in place with a square of 3M VHB tape applied as…
Scanned from an original using a Revopoint Metro X.
I found a loose ASRock KBL-NUC board in the trash so I made this case. You'll need some M4 hardware to assemble it: https://www.mcmaster.com/91290A176/ https://www.mcmaster.com/93722A205/ https://www.mcmaster.com/93475A230/ You can…
You'll need to desolder the SDL connector and wire directly to the PCB. Attach Teensy to the printed piece using 3M VHB or similar double sided tape. Use something like Soarer's Converter firmware on a Teensy 2.0. You can also use an…
Fully reversible mod, no cutting, filing, etc required. Fits the IBM Model M 1392595 terminal keyboard and many other variants while still utilizing the stock controller board (converting protocol using Soarer's converter firmware or…
I had the DXF cut out of 1/8" 304 stainless steel by Sendcutsend for about $70. You'll need some standoffs and screws too. I used these: https://www.mcmaster.com/94868A616/ https://www.mcmaster.com/90128a211/…
Simple jig to measure loaded and unloaded trailing arm angle on a Porsche 944. Limiting block/spacer must be removed to measure unloaded/full droop angle. My car had a bachelor's lean and all driver measurements were lower than passenger.…
A (very close to) 1:1 copy of an IBM 3276 door retainer. Will probably fit any other similar beamspring doors. Category: Parts
These are all currently available results.
