Counting matching models…
Some times your bath has no enough space for certain accessories. I had that problem with the GREAT DESIGN https://www.thingiverse.com/thing:5151237 I did modify it for two and four brushes, using less space. This is the result.…
This is an ultra compact holder for two 18650 batteries. If you have just a little bit space for placing the batteries, you need this thing. Its walls are very thin, but are even strong. You will have to put two wires between the holes in…
Taking the things GOTHIC LANTERN https://www.thingiverse.com/thing:2395716 and CHAIN GENERATOR https://www.thingiverse.com/thing:28405 I built a complete lamp, by adding a new thing for base and leds light, that is connected to 220Vac…
When you need transform a 608zz bearing into a tire or simply add to it some rubber for 3d carriage application or make the bearing can roll over an alluminium profile, you can use this thing. It's a rubber with the dimmensions of the 608…
How many times you lost the plate of the motherboards? This is the one for Asrock 960GM. Print Settings Printer Brand: Prusa Printer: Prusa Clone **Rafts:** No Supports: No **Resolution:** 0.2mm Infill: 20% Category: Computer
This wheel was used as rotating wheel in mini robotics vehicles. You can also use a M3 screw as axis Enjoy it Print Settings Printer: Prusa clone Rafts: Doesn't Matter **Supports:** Yes Resolution: 0.2 **Infill:** 25% Filament: MAKER…
This carriage is based on http://www.thingiverse.com/thing:2202796 . Congratulations for your design! It was adapted for using with 608zz bearing. There are two parts: carriage and ball support. The ball support has 51mm between balls,…
This is a paper towel from UMBRA brand. Thanks to Norhisam Bin Sakiman from Malaysia, owner of the design. The think is adapted to 200mm paper long x 100mm paper diameter. You can scale it for any size. Print Settings Printer: Hypercube…
This is a replacement for the original blowing of the Prusa extruder. Simply replace the other one for this one. It has a 50mm turbine instead the 40mm cooler. The wind is directed to the printing part. Once installed, you will be able to…
This is another simple autoleveling pasive mechanism for hypercube. These are parameters for Marlin config: Distance from hotend: X = -41.5mm (41.5mm to left side) Y = 0 This thing was tested and is working fine. This is stronger than my…
I didn't want install the power supply outside the printer, so I put the power supply inside the printer and I made this power plate. You can fix it on the 2020 profile. It is fixed to the same profile by two M4 screws in the front and…
I made a remix in order to adapt this thing to use with the hypercube 3d printer. Print Settings Printer Brand: Prusa Printer: Prusa Clone **Rafts:** No Supports: No **Resolution:** 0.2mm Infill: 25% Notes: You will have to use for…
Taking the thing http://www.thingiverse.com/thing:351236 , I made some improvements, as magnetic joint, spool holder, endstop switches, carriages with 608zz, effector with autoleveling sensor and power plate with switch and fuse. All was…
These are all currently available results.
