Counting matching models…
There were several deodorant/old spice holders out there already but not one that has the stick on its side. The finger grips don't really do anything but I realized it at the end of designing. I think it looks better with them and it was…
The 9 drawer has a different drawer shape than the other Alex's. Luckily the drawers are almost exactly 7x10 grids, I added 1mm padding all around for a tight fit. Because you assemble the drawers it can vary a bit. For each drawer print…
Holds an 8" silicon wafer for display
I've been using the same Radioshack solder spool for 20 years and just refilling it when it runs out. I didn't want to give it up so I remixed the original model to cradle it. This should hold 3 desoldering braids and 2 Flux pens. The…
I've found the soldering tip hole to be a little tight, at some point I will increase the hole diameter.
A ring to hold a full size Solder Sucker on a HSW wall
Mount a Fluke 87V to a HSW configuration while keeping functionality.
A simple flange for 3/4" PVC conduit. It has a closed bottom and 4 screw holes. I designed it to be in compression but damnit Jim I'm an electrical engineer not a mechanical engineer. I made it to help take the sag out of a particle wood…
My car trunk is electrically operated and if the garage door is open and you don't manually prevent the trunk from opening all the way it will smack into the garage door. The hinges are the lowest part of the door so the trunk hits them…
I really like these pump bottles for dispensing Isopropyl and the squeegee I use as a bench scrapper to clean debris off the work surface and onto the floor where they belong. Now they can join my back of bench gridfinity organizer.
I didn't like storing the ESP32 that runs WLED in one of the hex bodies because it can make wiring harder and cause shadows. So I designed this small box to hang below using the same screws. The width of the box is just right for an…
These are all currently available results.
