Counting matching models…
I had a few sockets I needed to organize and I had many holders over the years and they all were different. The cost to buy something new for all the sockets would have been to much money so this was my very first design to save money. It…
I took the great model that Yosuke built and just added a 5.1mm slot to the inside so it would be easy to install the feet with t-nuts for the 3030 extrusion. The same settings from Yosuke I am very sure would work but I personally…
Could not find these any longer so created them in Fusion and printed them out in TPU98. Seems to be working fine so far, and if they do fail I will just put in some new ones :) I printed them flat so the filament would be pulled in a way…
A basic case that holds 2 EPIPEN that I designed in Fusion. I uses friction for holding the cases together. I suggest printing a partial lower and upper case - 1 - So you can tell if your version of the pens will fit into the bottom case…
Printed off gigi's version of the funnel and had issues with the bottom breaking sometimes because of how thin the bottom section is. I am learning Fusion and thought, I can make that and make it thicker so it will be more robust. Printed…
These are all currently available results.
