Counting matching models…
Sleeve that slips over the 2-stroke oil fill cap that reduces the build up of dirt to the underside of the cap lessening the chance of dirt being introduced into the oil tank during oil fills. Print simply slides over the top of the cap…
Support bracket for the Nissan Leaf charger 30 amp charger adapter as included with the 2022 model. Inside dimensions are 4.25" x 2.625".
Two color print. Designed for 2 inch receivers. Scale as needed to fit other sizes.
These pieces will allow you to run the KTM headlight (I believe the year range is 2017-2022 on this style KTM mask) on Alta motorcycles already using the KTM front fender fitted to the stock Alta triple clamps. Also allows MX and MXR's to…
Adapter fits hose and dust shoe fairly tight, might want to reduce scale slightly. First print worked well enough for the task that I didn't feel the need to print another. Printed in PETG for my first piece.
Oil drain pipe for doing oil changes in KTM, Husqvarna or Gas Gas motorcycles (or anything with a M12 x 1.5mm oil drain bolt thread). To use, lay bike on side, remove drain plug, screw in drain pipe (I put a plug in the end of the pipe),…
Wall hanger for your guitar straps. Works with both Schaller and Dunlop strap locks, as well as just a standard strap with no lock. Two color print. Attach with good double sided tape or you could use small screws through the strap button…
Mount is print in place hinged design and is uses (2) 3/8-16 x 1 ¾" bolts for the clamp. There are two locations for a captured ¼" nut or bolt to attach various light duty accessories such as a metronome or a phone mount etc. Phone mount…
Wall hanger for your guitar straps. Works with both Schaller and Dunlop strap locks, as well as just a standard strap with no lock. Two color print. Attach with good double sided tape or you could use small screws through the strap button…
Simple slim handle designed to fit the somewhat non-typical stem shape of the StewMac dragon hand cut rasp/files. I only have the small size to verify fit, the design may fit the larger sizes I just can't confirm that.
This shim works to take up the clearance between the lever pad and the brake light switch when installing a brake light switch onto an off road only bike that was not originally equipped with the switch, or when adding the clearance take…
Part can be printed in two pieces without affecting functionality. Attached are both the two piece and one piece model files. One piece print will require supports, two piece will print without, just add brim and print. On the two piece…
Just print and install, drill small pilot hole for self tapping screw, insert screw and done!
This piece will replace the little brass threaded inserts that commonly pull out of the plastic on the rearmost rear fender attachment points of an Alta MX and MXR, or the second to last pair on EX, EXR, and SM models. There are models of…
Guide attaches to the rear fender (3M double sided tape used in pictures) to guide and support a dune safety flag on an Alta Redshift motorcycle. Curvature made to match the contour of the rear fender in the approximate position shown in…
This mounting plate is to aid in mounting a Curt trailer brake light wiring converter box such as the Curt #56227 for the Nissan Leaf. It's sized to fit a 2.25" wide unit and has a 3.1" tall recess to fit the raised area of the converter…
Simple bushing for the header bow guide pin on a C2 Corvette convertible.
Print hole side down, no supports.
These are all currently available results.
