Counting matching models…
Remixed a caliper holder by Klave (linked) for the honeycomb storage wall. Hexagon's (connector) faces was offset by -0.15 for snap fit into the blank insert needed for the wall storage. The blank insert can be downloaded at…
I've been playing too much Call of Duty lately and decided to make a print in place “quick-reload” paper towel holder. Largest paper towel I've tested is Costco's 6" diameter paper towels. Installation notes: When determining the spacing…
Holds a ruler to the HSW solution. I modeled with an -0.15 offset, so no need to size. It's print and play and should (depending on your printer's tolerances) snap into the HSW blank insert that can be found on the original HSW post.…
Mounting solution for HSW. Designed to print in half to avoid supports. Print Settings: layer height: 0.20 Perimeters: 3 Infill: 10% place the left and right side close together in the slicer and print both at once, as opposed to printing…
No supports needed, simply print-in-place and install. V3 incorporates the honeycomb storage wall features to attach some of your useful items. 2 versions: One version is to attach directly to the Honeycomb Storage Wall and a screw-in…
PS5 Controller mount for the Honeycomb Wall System. Designed to print in half to avoid supports. No glue needed, no supports needed. Simply insert both parts into an “empty insert” from the original HSW page and mount on your wall. Print…
Remix of a speed square mount by Votjz. Print Settings: Layer Height: 0.20 Perimeters: 2 Infill: 10% I hope you enjoy printing the design! To help me keep designing and uploading more things, you can tip me via 'Buy Me a Coffee' here:…
Loved the design and print of the KLIPPT and adapted it for my under-desk HSW solution. Print Instructions : The compliant hinge will work best with PETG , but ABS, ASA or even PLA will work as well but may break if open/close-cycled too…
Mounting solution for 2" sanding discs and Milwaukee's orbital detail sanding sheets. I plan on adding different grit sizes in the future, however if you need a specific one let me know. Print Suggestions: Layer Height: 0.2 Perimeters: 3…
HSW mount for the Switchbot hub. Print settings: Layer Height: 0.20 Perimeters: 3 Infill: 10% No supports needed.
My Sunlu S1 dryer is mounted on the top frame of a MK3S+ at an angle. Occasionally, the filament roll would bind against the dryer wall and it's heat plate, causing a print failure. The other options available were too flimsy and when I…
These are all currently available results.
