Counting matching models…
Strong and easy to print bracket for Nema 17 stepper motor. Bracket was designed from scratch for my DIY 3D printer. Main goals for design : bracket must cooperate with end mount for motor screew ( this means that some of its dimmensions…
This is cage for mounting o4 air unit lite on Betafpv Pavo 20 pro. To mount o4 Air unit lite you must use orignal bolts M2x4mm. There is also holder for o4 air unit lite antenna - use flat screw driver to open it and then place antenna.…
This is model of antenna mount for Walksnail Moonlight - designated for Speedybee Mario 5 drone frame. Question :Why there is no place for GPS at the end of the antenna mount ? Answer: For better load distribution and better GPS signal…
Knob for encoder module used in Arduino / ESP32 / STM32 projects. Dimmensions : D=23mm , H=14mm There is a circle mark on it to see actual position. Print time 14 minutes
This is special handle for M6 bolts with D=30mm. It is usefull if you want to screw togather two pieces of styrofoam. Wide nut wont sink inside styrofoam - it has nice feel and it can be used with long bolts. Tested on styrofoam 30mm…
Perforated Mug for pencils and tools. This is good model if you want to check your printer print quality. Print time about 5h. If you are not Flash then you shouldnt drink coffee from it.
If you have DJI o4 Air unit Lite and you need camera case to fit your drone you are in right place. It was designed for Mark5 fpv frame but it can fit in other frames as well. it is 19.8mm wide. Printed from any material you like. Printed…
It is easy to print tactical knife for future modifications. Use your finger to slide in / out knife blade. I do recomend to print blade & handle cover with better quality for better effect. Handle cover and case can be assembled and…
This is side plate to protect stack on SpeedyBee Master 5 drone. Side plate is only 0.8mm thick made from TPU - it will easy adopt to your motor cable layout. USB port is not exposed because I'm using wireless configuration - you can cut…
Pumpkin 7 DC drone frame need special holder for Walksnail Moonlight 4k Camera : Camera Holder made from TPU Material TPU: Print time about 1h (fine quality) Print speed 30-40mm/s Bed temperature 40 C Extruder temperature 228 C Infill 8%…
Pumpkin 7 inch DC frame TPU Holder for : Walksnail WS-M181 GPS Walksnail Moonlight double Antennas Material TPU: Print time about 2h (fine quality) Print speed 30-40mm/s Bed temperature 40 C Extruder temperature 228 C Infill 8%
These are all currently available results.
