Counting matching models…
It doesn't require any special settings, I printed it in PETG at 0.2mm resolution. It will probably fail to work if printed with a higher diameter nozzle than 0.4mm because the lip that holds the lid might not be strong enough.
It is a keycap set compatible with mx style switches. The files that start with keycap[...].stl are the blank switches that serve as a base for all the other. I included them in case someone wants to have some some custom keys. The…
I made this model because the existing ones usually had issues when reversing. There are two major changes in my design: The skis are symmetrical so reversing shouldn't be an issue The skis are higher to avoid compatibility issues. To use…
I wanted an organizer that has the advantage of quickly putting the cable on. It fits inside the slot in the case. Minimal supports are needed in the “neck” area. The cap is optional.
This is a Halloween diorama that uses 3 slides at different depths that give a interesting parallax effect. There is also a blank slide included if you want to create your own scene (or start from scratch, the slide dimensions are…
This is just a shim that was needed in my case for the iris to work properly. There are no special print settings, I used 0.3 mm layer height. The material doesn't matter. After printing check for any bumps or defects and sand them. You…
The model is thin and light so all the tricks must be used to make it stronger. I recommend printing it with the following settings: Layer height: 0.15mm Perimeters: 5 when using a 0.4mm nozzle Material: PLA or stronger. I suspect a hard…
those who use the Agile methodology might find these cards useful. Print instructions It is required to do a color swap at the half print (0.8 mm in PrusaSlicer). I would recommend to use a dark filament on bottom (this will be the color…
I wanted to use a magnetic mount for my cr18p, but none that I found matched what I wanted so I made a set. My targets: use 10mm magnets (round or square). They can be up to 2.35mm thick. do not raise the body minimal supports required…
The files are split based on the filament needed. in the opaque parts you have the iris and two variants of the case: a round one one that has a mount that uses an m3 screw (you will have to mirror along x or y to get both sides). The…
I wanted to mount a Raspberry Pi display on the side of a cabinet to get access to the Home assistant interface from a convenient location. Print instructions: the most important change is to use enough perimeters to get the sides strong…
Using Traxxas Big Bore shock with Losi mini t springs is a common mod to getting a good shock for crawling. Losi mini t springs are hard to find lately (at least where I live) but Desert Lizard springs are common but they do not fit as…
These are all currently available results.
