Counting matching models…
Updated model for the Knob Guards: Posted a new model. https://www.printables.com/model/923894-tyt-md-uv390-md-390-knob-guards-revised Updated model for the PTT Guard: V1.15 Added to files in this model. I tinkered with the design to make…
Just a simple collar that is redesigned from the previous model. Version 1 of the redesign is meant to be printed in TPU and it slides overtop the knobs. It is crude but works. Version 3.5 is a bit more detailed. It was meant to be…
This is a cover for the Kenwood connector port on the TYT MD UV390. It was designed to be used with a Commountain speaker mic. Version K Prints Face Up with Supports for the Screw. I increased the support roof distance to 0.3mm to help…
This is a 2 part model that is easy to print and assemble. The killflash itself is designed by another and then I customized it for this application. I customized it with 0.25mm walls and it is meant to be printed with a 0.2-0.25mm…
There are two groups of files for this. One is just the front and rear caps. The other is the front cap with a kill flash. Shockcord Cap with Killflash: I have ‘remixed’ and added to this kit by creating an optional front killflash/anti…
I used a kill flash design found here: https://www.thingiverse.com/thing:4875497/apps I created a ring that allows the user to snap it over the Credo 1-8 LVPO. My ring sets the grid back from the face a few millimeters to help protect the…
I sized the caps and ring to fit the Credo 1-8. This kit includes the all three models in one STL fit on a build plate for a Creality Ender3 V3 SE. I did have to run an 1/8" drill bit through the holes for the shock cord to clean them up…
Just a simple plug to fill open 12 volt power outlets. I printed this from TPU on a Creality Ender 3 V3 SE. I made this in Sketchup using a simple to print design that requires no supports. I printed this with a .25 layer height to match…
Made this model to attach an NMO antenna to a roll bar of a Honda Pioneer 1000 which is 1 ¾". I decided to make it fit up to a 2" bar and used a bushing to bring it back down to 1 ¾" for my use. I designed it to use 3/8" hole NMO mounts.…
Just a few parts I made while working on a CRF50F. It is two handle bar end fillers to reduce help the grips survive a fall without having a hold punched in the end of them. I also add a small bushing between the rear brake pedal pivot…
There are a few brackets already out there for installed Nvidia Quadro P1000 or P620 graphics cards in the Lenovo M920q but I found them to be weak. Most of them attempted to keep the look of stamped steel and thus were too thin. They…
This small plastic part is commonly broken on the EVX-500 series radios from Vertex. I made a simple replacement for it.
The head gasket of my Bostitch HP118K 23 Ga. Headless Pinner blew out and was leaking air. I printed up a new one in TPU. I added a lip to the interior diameter to help prevent it from blowing out again. Used a Creality Ender3 V3 SE with…
Holds a single CR123A/16340 battery and a single 1/3N battery. Clips into Magpul MOE pistol grips. I printed the main core in Overture PETG. Worked well. Supports are not needed if you enable "make overhangs printable" in the slicer.
These are all currently available results.
