Counting matching models…
It's a horn that could be mounted on a harness on a hobby-horse, mounted by a screw though a hole in the harness. It contains 3 different horn sizes, as seen on the picture but by modifying the supplied *.scad file in OpenSCAD, you can…
Print approx. €3.04–€3.71 excl. taxPreliminary estimate for PETGSource material: PET
Parametric hobby horse holder based on a design from @Wejrice but since the one of the screw holes was off, I completely redid the model in OpenSCAD. I added a table clamp by 247generator which I extended by a bottom part, cleaned up and…
One base to construct a hobby horsing jump hurdle. You will need two pieces connected at the ground level with a 20mm diameter rounded wooden pole and two 20mm diameter vertical poles. At the top, you can use sliders from this model: No…
Crossbar holder that is put on a 2cm diameter wooden pole (height can be adjusted by sliding) and holds a crossbar for jumping over it. Goes together with the hurdle stand: You would need to print both the stand and the crossbar holder…
These are all currently available results.
