Counting matching models…
All props to Pattersaurus on Thingiverse for this. * You'll need THREE M3 x 8mm Screws / Bolts (no nuts) to attach this to your machine. * ****PRINT ORIENTATION**** - fins and holes face down on plate: Just as the first photo, place it on…
:IMPORTANT THREAD / BOLT INFO: I had to scale the clamp bolts up in size about 1-2% and the bolts for the base about 3-5%. That's what worked for me and FOR MY LIKING - everybody's setup is different, your mileage will vary, everything…
All components should be sized correctly as-is. I've individualized everything. I can compile them in a grid as one file upon request. Solid and easy to print helping hand setup for your desk or on the go. Components needed: 1x Body &…
The stand lets you install the heater to either blow upward or blow downward in your machine. Deflector only sits on top of the heater as its facing upward blowing heat towards the top glass. Nothing fancy. The tolerances were perfected…
This was very crudely done but it works and works well for what, I myself, needed it for. 1st Gen with the silver metal bar feet. The E2 is slightly shorter, the feet are a bit further in and there's a circular intake fan / grille on the…
Remix of a model I found on here. Originally intended for a Peg Board. If you have or want the Peg Board version please refer to Les Burris' post link below. I removed the pegs and made the back solid so I could stick this on the side of…
Some may have one of these already or may be wanting to buy one of the kits. This is the case file if you were wanting to make your own. Original creator / Github: https://github.com/keyboard-magpie/isopad
Previous models people have “drilled” into the case to run wires wherever they may. That seems unfinished to me and I do not want a loop of wires hanging out the side or wrapping around. -Supports 100% of the time ONLY for the OLED…
These are all currently available results.
