Sunlu E2 *1st gen* Riser | Legs | Storage | Filament Drying
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Medium riser for Sunlu E2 Filament Dryer 1st Gen with the silver metal bar feet.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 19
- Makes
- 0
- Views
- 307
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Public Domain
This was very crudely done but it works and works well for what, I myself, needed it for. 1st Gen with the silver metal bar feet.
The E2 is slightly shorter, the feet are a bit further in and there's a circular intake fan / grille on the bottom side. All models have been resized, chopped, or adjusted so you can sit the dryer onto it easily.
9.6 inches tall.
Hardware:
M2 thru M5 assorted 2000 piece Kit (non self tapping but useful for everything - there's a 2240 piece M3 only kit on this same link) https://www.amazon.com/dp/B0CQJZCC9T?th=1
M3 Self Tapping 500 piece kit https://www.amazon.com/dp/B0D1R21JRR?th=1
Assembly:
I used M3 self tappers for the small middle square bracket that secures both support bar halves.
Same M3 self tappers to secure built support bars to each riser end.
Install 2 support bars on the back side - one very top, one very bottom.
Install 1 bracket in the front either at the top, feel free to print more support bars / beams to fill it up as much as you want but I wouldn't use less than three.