Sunlu E2 *1st gen* Riser | Legs | Storage | Filament Drying
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Medium riser for Sunlu E2 Filament Dryer 1st Gen with the silver metal bar feet.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 300
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Public Domain
This was very crudely done but it works and works well for what, I myself, needed it for. 1st Gen with the silver metal bar feet.
The E2 is slightly shorter, the feet are a bit further in and there's a circular intake fan / grille on the bottom side. All models have been resized, chopped, or adjusted so you can sit the dryer onto it easily.
9.6 inches tall.
Hardware:
M2 thru M5 assorted 2000 piece Kit (non self tapping but useful for everything - there's a 2240 piece M3 only kit on this same link) https://www.amazon.com/dp/B0CQJZCC9T?th=1
M3 Self Tapping 500 piece kit https://www.amazon.com/dp/B0D1R21JRR?th=1
Assembly:
I used M3 self tappers for the small middle square bracket that secures both support bar halves.
Same M3 self tappers to secure built support bars to each riser end.
Install 2 support bars on the back side - one very top, one very bottom.
Install 1 bracket in the front either at the top, feel free to print more support bars / beams to fill it up as much as you want but I wouldn't use less than three.