Counting matching models…
Stand for the AVM FRITZ!Repeater 1200 (AX). An Europlug extension cord is needed to fix the repeater to the stand. Make sure the extension cord fits the cutout on the back as they differ in size and shape. I've used this one from REV…
The clip (1Z0857561) for my sun visor in Skoda Octavia 1Z broke and I wasn't able to find a matching replacement part online. Luckily there is already a fitting model on on Thingiverse but it is slightly higher than my original part. The…
This is an adapter to use existing Pico 4 lenses from VR Optician on a Quest 3 VR headset. After printing I had to carefully cut away some blobs on the outer side part that clicks inside the lens frame of the headset to make it fit. Be…
Replacements for the original controller mount arms on the old AMVR headset stand to use it with Quest 3 controllers. Note: If you use the step files, mirror both parts along the Y axis to get the counterparts for the right controller.…
After upgrading my SR-P Lite pedals with a load cell I wasn't happy with how they felt with their smooth plates and shallow angle. I found some decent looking and priced pedals on Amazon and created adapters for mounting them in a more…
One of the sliders for the chest strap on my Osprey Radical 26 backpack snapped when I tried to adjust it. The slot on the original design is only 16.5mm wide but the strap on my backpack is about 20mm. I scaled up the model to make the…
Printed best for me with 100% infill and 0.12mm layer height on my Ender 3 Pro.
Feet for the Playseat Challenge. Adjusted to be used with these Pedal Reinforcement . Print parameters 0.2mm Layer Height 5 Walls 15% Infill
This replaces the BOBOVR Battery Dock and allows you to use an external power bank in its place while retaining the “hot swap” capabilities. I went with the Anker PowerCore 10K Pro. The magnet holes in this remix are reduced to exactly…
This part replaces the power button on a Garmin Oregon 3xx/4xx (probably also other models from the same series). Print the cover from a flexible material like TPU and the pin from a solid material like PLA or PETG. Both parts need a bit…
DPSG-Lilie zur Verwendung mit diesem (Rover)Halstuchknoten. Zweifarbig drucken oder mit einem Lackstift anmalen. Print parameters 0.2mm Layer Height 100% Infill Ironing top layers (recommended)
The stock throttle pedal with just the spring had to little resistance. After searching for a solution I found that higher priced pedals have hydraulic dampers installed and decided to create my own mod using a AD1425-5. Materials needed…
These are all currently available results.
