Counting matching models…
Please keep in mind that this only fits the GPX 2. Enable tree support for cleaner screw holes and easy removal. Can be printed out of any material, preferably stiffer ones, but still very usable even with PLA. Base alone saves around 8g…
Stream Deck MK.1 Faceplate Replacement This faceplate is meant to completely replace the original one on the Stream Deck Mk.1, in order to create a smaller footprint and have the faceplate be flush with all sides of the device. Follow…
Jakeu's Tofu60 (Redux) Wrist Rest IMPORTANT: In order to print this model, you'll need at least 256x256x80 mm of space on your bed You'll have to install 3M™ Bumpon™ SJ5344 rubber bumpers (19.1 x 4.1 mm) for it not to slide on your desk…
I switched from Kamui Roku to Taom V10 as my chalk of choice, and since I can't live without my Kamui Chalk Shark, I designed this holder! There is also a press fit lid included - please keep in mind that the press fit is optimized for my…
jakeu's Wooting 60HE Optimum Wrist Rest Wooting didn't make a matching wrist rest for the Optimum collab, so I decided to make my own! Printing Instructions High bed temp, brim or even glue is highly recommended to make sure the top…
This base replaces the original one found on the NP-01S 4K in order to save up to 9g. Please keep in mind that the buttons on the bottom of the PCB are hard to reach after installation. Feel after installation is close to stock, but…
Tolerances are rather tight to make sure it doesn't fly out when cranking 90s in Fortnite. Made by Jakeu jakeu.gg
Check out the original design here. How I printed it: PolyTerra PLA (White) 10% Box Hatch Infill (5% Gyroid should also be more than rigid enough) 0.28 Layer Height You can also add silicone or TPU feet underneath to make it more secure.
For normal 256mm square print beds, this design needs to be printed on its head as shown on the third picture. Brim and either a smoother plate or even glue is recommended to assure it doesn't fall during the print. For the highest…
A simple mounting bracket for the Elgato Wave XLR Pro. PLA 5% Gyroid is plenty.
A under desk mount for my old Focusrite Scarlett 2i2 and my new FiiO K13 R2R. I realize that pretty much no one will have this exact combo, but since one of my viewers asked for it, I figured I just might upload it. Especially for those…
These are all currently available results.
