Counting matching models…
Fits at least 8200i. Feed film into adapter - align negatives with the frames. Scan 6 negatives, retract to position 1. Pull film forward 6 frames. Repeat until end. Do not forward to frame 7 until the last photo. Absolutely room for…
So, I did not find any good hammer holders out there - neither commercial nor DIY. But, Prusa to the rescue. And the quicksquare as well! Very useful while renovating my garage. The hammer is fastened with a magnet - I use a 50mm by 20mm…
Simle wall mount/holder for Ikea Klockis. This simple little eletronic timer/temperature/alarm/clock is a steal for the motorhome for timing the boiling of your eggs, and useful for monitoring the temperature.
The original holder for my T12 soldering iron is loose - at best - and I figured a suitable PETG replacement would do the job. So far so good, but maybe ABS/ASA+ is even better for heat resistanse. Snug fit for the KSGEG T12 handle with…
This is a simple snug fit/snap in holder for the Alphatronics TV/sat remote and a ChromeCast4 remote. This TV is used in Frankia motorhomes - probably other places too. Blank back to simplify mounting to wall or under cupboard surface…
Wire spool, modular, print as many as you need, with room for feet on end or in between spools. Axle is screw M14 adjustable with 3mm allen key Left side with holes to attach wire end all around the rim Right side with cutoffs to make rom…
Many similar items have weak “posts” - here 3x3mm thick solid posts, recommend printing in PETG for slight flexibility and durability. I print in white with 5° higher temp for best layer adhesion.
These are all currently available results.
