Counting matching models…
It is intended for use with a volcano nozzle with nuts covering the threads or a melt zone extender that takes standard V6 nozzles. I am not sure if it will work for a volcano hotend but that is not what it is designed for. Print in…
A simple snap cap/dummy round with a TPU primer insert. Print the snap cap in something rigid with good layer adhesion and the insert in TPU. The snap cap should survive cycling a few times if you aren't too rough with it. Always cycle it…
Start the ring onto the round be putting it on a flat surface, then push the bottom of the round into it to start it. Work it up the dummy round to its groove. When printed in 95A TPU it should be able to stretch enough.
These are all currently available results.
