Counting matching models…
The original one of these touched the silicone sock on my Ender 3. I lowered it a little bit so that its just about .5mm above the nozzle. This keeps it away from the sock totally and puts it a bit closer to perfect aim on my printer.…
I didn't want to spend $40+ on a bending mandrel to use for 4 tubes one time, so I drew this up quickly. There are bends for 90 and 45 degrees, as I figured 180 wasn't that commong anyway. It's set for 14mm OD tubing. Smaller should work…
I am building a 2020 extrusion framed pen plotter and laser engraver, but needed a way to sit it up off the base of the build board. I didn't see anything on here that also had a mount to screw down to the build board, so I modeled it up…
I quickly whipped this up to put feet on my bartop arcade cabinet project. Hole is sized for an M4 bolt with a button head. I the glued 1/8" thick cork sheet to the bottom afterwards to create a non-marring, non-slip surface for the…
I just turned the mount on this 90 degrees so that I could mount it on top of my Ender 3 for a top mounted spool and direct drive extruder. Category: 3D Printer Parts
I was building a wall in my basement and needed to run some Romex to it, but it didn't line up with an easy place for a splice box. I ended up getting some 1/2" metal conduit, running the Romex through it and then into the wall. NEC…
Built this to mount a ‘standard’ NEMA14 round 36mm toolhead PCB to a Hemera XS. The only board that officially supports the Hemera XS is the Duet one. For anyone wanting to run Klipper with a CANBus toolboard, this was necessary. Print:…
The way my new PC build is going to sit on my desk, It would be at an angle and cables would be visible. I drew this up quick in Fusion360 to cover up and route the cables around the back and through the grommet. It's simply doublesided…
I remixed a model that mounted the sensor on the outside of the fan to go between the fan and heatsink so it was closer to the nozzle. Got tired of trying to shoehorn a BLTouch onto a Hemera XS Revo and having it be 50+mm away in both X…
These are all currently available results.
