6 models
Just a cute little Bongo Cat pin. You can print it in 2 different colors by switching filament ! (at the beginning of the 4th layer if you print it in it's original size). Print different Bongo Cats in a single job by squeezing them on…
The LDO metal plate (20x50x0.9 mm) should fit well in its slot if your printer is dimensionally accurate. Play with the "X-Y hole compensation" setting if it's too wide / thin (be careful to keep the 3mm screw hole diameter correct as…
Designed for 1cm-wide LED strips with 60 LEDs per meter, 3-pin connections and protective coating (e.g. IP65 strips). Can be printed on a V0 print bed. You'll need 2 stripes of 8 LEDs and 4 M3x6 screws in total. I used 'Slide-in Nuts' to…
Here’s a funny "Awesome Face" pin. You can print it in 5 different colors by switching filament ! (Switch at the beginning of the 3rd, 4th, 5th, and 6th layers if you print it in its original size; check the color order on the last…
These modified skirts are based on the original V0.2 skirts. You can simply replace them using the same screws, without any additional steps. I changed the filament color at 0.6mm and then at 3.72mm layer height. You can adjust these…
Remake from @nuxnik, using 3x Rubik's cube holders, attached to a plate, that can be sticked to a wall.
These are all currently available results.
