Counting matching models…
A flying propeller launcher. flys farthest when launched horizontally. Comprised of three parts; Propeller, Base and Cord. The propeller is loaded by fitting it onto the peg that the base has. The cord is then inserted into the slot on…
A tray for the arm of a couch you can place a drink on or keep a remote on a flat surface. The sides are flexable and cover the sides of the couch arm, anchoring the tray in place. print with brim and open chamber door to prevent warping.…
A portable fan powered by a hand crank and TPU pully belt drive. DRIVE BELT MUST BE PRINTED WITH TPU .2mm layer height outer brim on all parts for adhesion slim tree supports for both pullys To assemble place both large and small pully on…
Printed in PLA To assemble push one of the bearings into the slot at the base of the basin, then insert the bottom of the screw, at the top of the screw put the other bearing. to the side use the extrusion to judge how far the big pully…
A trash bag holder that attaches to the side of a table or desk using screws. .2mm layer height 15% gyroid infill organic tree support on build plate only outer brim mm To assemble attach main body to table and screw untill it stays in…
I love construction equipment and while on a road trip I saw one with a design that I love. This is a model version of what I remember with a working winch and wheels. .2mm layer height. Outer brim for parts slim tree supports for all but…
Flexible Impeller Pump driven by hand crank and planetary gearbox. The gears, impeller and bearing cover should be printed in TPU. Everything else in PLA. This print seals the impeller inside the housing. This is done by pausing the…
The Elixer Pump from the clash series Made in five parts everything printed in PLA except the tank which I used transparent PETG for. .2mm layer height and snug auto support from the slicer. Outer brim to prevent warping. Asembly is…
A basic toolkit for doing DIY chainmail. When using pliers grip rings using the middle for most grip. The opening ring work well and was designed around 18 gauge rings.
The Inferno tower from Clash of Clans/ Clash Royale. .2mm layer height, slim tree support, outer brim for bed adhesion. Includes the Single and Multi traget configuration which have a hole on the top.
3d printed eye protection. Made for users who have low risk requirements for eye protection. I designed this because a few time while removing supports from prints using pry tools plastic has launched at high speeds and almost hit my eye.…
A compilation of models that use suspended printing techniques. This project has 3 models; a suspension string test, a suspended Ovenpheus decoration and a suspension bridge. When I made this the largest challenge I had was getting…
A Ford Taurus model to honor my old car that got totaled. To assemble push wheels into place on bottom frame. then attach wheels and frame to car body by pressing the two pegs on the frame into the two holes on the bottom of the car.
A fully 3D printable mechanical pencil that uses 0.7mm Lead and a 3d printed pen housing that for 3.4mm ink cartridges. Three designs, A mechanical pencil that uses a compliant mechanism to hold the lead in place, A compliant mechanism…
These are all currently available results.
