Counting matching models…
Prefer print thread area for layer height smaller 0.16 for the overhang of thread, 0.12 will be great. I use varies layer height in superslicer, I print other layer at 0.22 height. I use ABS so I can put the spool in the filament dryer.
The main goal for this mod is that I can clean the nozzle after I pause and resume the print, which is usually make small leakage of nozzle. You need 2 heat insert for the brush holder, to fixed the holder on the frame mount. Another 2…
I want filter out the tiny dust in the bottom of cat litter, so I don't need throw whole box of cat litter away. I print at 0.24 layer height without support for PLA.
Printed with PLA. I use 80cm long 26cm diameter plastic tube as led, but it can vary depend on your need. The crocheted bed is around 80cm from one end to another, but it can adjust depend on your length of tube/stick, and position of the…
I want a bring soap when travel; I want it air tight to prevent water leakage, and a grill to drain water when using.
The 2 3010 part cooling fan usually isn't enough when you want to print faster with material like PLA. Since I put my printer outdoor, so I don't want take off the side panel to prevent the dust. So I use the base of…
Need to drill two holes on the stock side shield to attached, or just glued.
If you are not preload extra M3 nut, you can drop M2.5 nut and use M2.5 screw instead.
Not a fan of most commercial cat litter mat. I want it modular and can easily to separate to clean. !!! Caution !!! When installing the magnet, be careful about the polarity. The polarity should be 180 degree rotation symmetry, ie. when…
If you can't full panel, print L and R, and use 2 heat insert each side, and screw the “lock” piece to assemble. The panel in the picture is older version, in the new version you can install 40mm fan on each side, which will cooling your…
you need few heat insert for install V0 display.
These are all currently available results.
