Counting matching models…
this was printed in Prusament silver PLA using a 0.6mm nozzle 2 walls/2top and bottom, 0.4 will also work fine but I would recommend 3 walls/top/bottom needed a booster to raise the height of my corsair case to fit a blueray drive…
designed to circulate and remove warm air from my house in the middle of summer. At the time I was mining ETH and this brought my house temps down by a few degrees C. Can add more fans to the grid if required, the fitting points are…
Printed in PLA 4 walls 50% infill printed on side 195 degree nozzle 60 degree glass bed with hairspray (likely hairspray not needed) seems tough enough. you may wish to rough up the face which attaches the the surface of the item you wish…
needed a kickstand to hold the tidy open when rearranging cables or playing on the consoles inside to prevent overheating. couldn't find an existing model to print so made this in fusion silver part is glued in place to reinforce the…
These are all currently available results.
