Counting matching models…
Nothing special, the small tabs needs to be supported for printing but the provided 3mf shows how to add this support. An exacto or small screwdriver will help remove the support. Make sure to clean properly the underside of the tab (so…
This is a simple waterproof casing for a Miniwhip antenna clone from China. This particular antenna is 80mm x 35mm in size, with a supplied power injector. I designed the enclosure to be waterproof. The two parts are joined by a thread.…
This integrated RTK bluetooth receiver uses a F9P module coupled to a calibrated antenna. It's very recommended to print the parts with PETG (to provide a better protection) and to finish them with a sealant. Some supports are necessary,…
I recommend to print using ironing for all top surfaces, with a 0.15 or 0.1mm layer height. You can use ironing on the surface on the squares to get a better finish, it adds a bit to the print time but it looks much better. Mold is using…
These are all currently available results.
