Counting matching models…
This allows you to fasten a 3" flexible duct to the QiDi Q2 exhaust port. The original model that I remixed this from (thanks Weav ) was very good but I had already designed other duct work that had a lip at the end of the tube to “catch”…
Introduction A waste bin to catch the considerable purge waste that the printer produces. There is a bracket that uses the existing 3 screws around the waste chute on the back of the printer for fastening. The bin is connected to the…
This waste bin for the back of the QiDi Q2 printer is magnetically attached and easy to remove and reattach assuming you have easy access to the back of your printer. It consists of two parts: a bracket that you screw into the back of the…
Introduction This remix expands upon tools used to temporarily hold the A/B drive belts of a VORON Trident or 2.4 printer on the X axis while installing the toolhead. The VORON StealthBurner has belt clamps that face the carriage of the X…
The original zip-tie cable clips by motocoder were great (perpendicular variety), but it routes the cable down the center of the extrusion. I needed it to route down one side of the extrusion as my tool head overlaps the extrusion some…
This is for the excellent ratrig toolhead v1.0 beacon mods by Ferdinand. That mod worked very well, but this piece broke and I wanted to make a sturdier version. Printed with glass filled ASA.
These are all currently available results.
