14 models
I made a reference board of the various predefined percentages of infill that are presented in PrucaSlicer, just to get a better overview. In the gcode file, all 14 predefined modes from PrusaSlicer are already configured as shown in the…
Hanging lampshade for socket E27, for hanging in windows, for example. Diameter 15cm Height 13.5cm Fits E27 Including Lamp Ring for E27 Socket. Should be printed with 3-4 layers at the bottom and then Vase mode. Was a beautiful result…
Lampring for lampsocket E27 Diameter 5.5cm Height 11mm Fits E27 Printed with out supports. 2-3 perimeters 15% infill is good enough Was a beautiful result when it was printed in PLA Wood. The threads have a good fit and have been tested…
I needed some form of protection to cover the poles of a car battery, and since car battery poles have a standard, maybe it can be useful for someone else. So I drew them in Fusion360 and test printed two pairs. The prints have positiv…
Lampring for lampsocket E14 Diameter 4.3cm Height 11mm Fits E14 (E27 ring in the pictures) Printed with out supports. 2-3 perimeters 15% infill is good enough Was a beautiful result when it was printed in PLA Wood. The threads have a good…
I drew a diffuser for Mini Maglite which gives a good spread of light in the dark. Fits lamps with a diameter of 25.4mm (1 inch). Printed in transparent filament with 15% infill (Gyroid) to get nice light scattering. The diffuser has an…
This is a practical footstand for the Mini Maglite. Fits flashlights with a width of 18 mm (0.71 inches). The base is 35mm (1.38 inches). Fits with Mini Maglight Diffuser which you can find here.…
I made a small holder for some hygrometers/thermometers that I bought on Amazon to keep an eye on the environment next to my Printer. Simple and easy. Prints with the hole down towards the plate. No need for support. Fits perfectly and…
Cover for lampsocket E27, for hanging in windows, for example. Diameter 4.5cm Height 8.5cm Fits E27 Printed with out supports. 2-3 perimeters 15% infill is good enough Was a beautiful result when it was printed in PLA Wood. The threads…
Standing lampshade for socket E14, for table laps, for example. Diameter 20cm Height 15.2cm Fits E14 socket Including Lamp Ring for E14 Socket. Should be printed with 10 layers (2mm @ 0.20 layer) at the bottom for stability and then Vase…
Hanging lampshade for socket E14, for hanging in windows, for example. Diameter 15cm Height 13.5cm Fits E14 Including Lamp Ring for E14 Socket. Should be printed with 3-4 layers at the bottom and then Vase mode. Was a beautiful result…
Here is the XXL-version of the diffuser for the Klarus XT21X flashligt. :-) Handy when you need to turn all that concentrated lightbeam to the surroundings. Perfect on the kitchentable during that poweroutage, in the garage or on that…
This is a flashlightstand for the Klarus XT21X model if you ever need. It is a litle hard to get the flashlight to stand up right when needed. It is used in combination with the Klarus diffuser that you can find here. The Footstand is…
Here is the diffuser for the Klarus XT21X flashligt. Handy when you need to turna all that concentrated lightbeam to the surroundings. Perfect on the kitchentable during that poweroutage together with the Klarus Fottstand that you can…
These are all currently available results.
