Counting matching models…
This is a coin holder for your coin collection to put on a shelf or show-off. It can easisly be scaled up or down. In the original size, I suggest a maximum coin diameter of 60mm, which should be fine for most coins. Print with:…
Users of the kinda cheap-ish Eastwood powder coating system know about the problem around uneven air distribution in the powder container. You often get clumps of powder out of the nozzle or no powder at all until you shake the bottle…
This is a storage for up to 5 18650 cells. You can optionally thread a rope throught the center hole and put a knot at the bottom. Print with standard settings: 0.2mm layer height Speed of your choice any filament is fine The threads need…
This is a little helper to properly measure hole distances. Put two of the cones on the tips of your caliper and slide together. If your value is bigger than 20mm, note that down and substract that overhead from your measured value.…
As I dont use the drag chains from Squirrelbrain's V-Minion mod, I needed a suitable X end cap for the wire loom holder. It matches the overall design and is compatible with the Z belt tensioners. Opposite to the original V-Minion X end…
Parallel setup for 2 x 18350 batteries. I made this thing because Dipp3d sent me the wrong sled for the nano enclosure. Be sure to only activate supports from the print bed as the bore for the negative wire should stay free of support!…
Edit 13.04.2019: Due to request, I added a version without the brass inserts. The screws are directly screwed into the plastic What you need: 4 x M3x4 inserts for the bottom 4 x M3x5 inserts for the hotend fan and to clamp both parts…
As the carbon rods are very difficult to saw to the EXACT same length, this jig helps you to align each pair of carbon rods to be the same length. Instructions: Screw the 20mm set screws into the steel balls Cut the rods to rough length…
Remix of the original extruder for the awesome Tantillus Reborn by Lars. Check out www.scheuten.me for the Tantillus R project! I didn't like the original extruder with the MK7 gear and squished bowden tubes. So I remixed the extruder to…
These are all currently available results.
