4 models
Updated December 7, 2024- Brackets now slice properly in Orca Great design by TianZi. Basically the same as the original but minor adjustments to fit K1C door holes and also allow room for the seal/strip on the door. The clips are the…
Scaled to fit K1C aux fan. Everything else is the same. All credit goes to Snuffypot for the great design. See original for assembly/installation.
Remixed for K1C with 6mm Lexan (PC) side panel(s). Roughly sliced together, you could definitely make them cleaner and with better tolerances. They are tight, I had to sand down a couple edges bc I made the tolerances too tight. I…
Heat Shield with 40mm Air Mixer Fan. Remix of gdramos's model on Makerworld. The added chamber heater in the K1C was heating up the side so this remix helps spread the heat. The 40mm fan aids in mixing the hot air and keeping the heat…
These are all currently available results.
