Counting matching models…
I rotated the position of the female USB connector such that it is pointing forward rather than to the right. It uses the same 8" USB extender linked on Amazon.com . I didn't have color matching filament so the item pictured is plain…
I printed this in PETG but PLA would work also. If you are using a fixed layer height you probably should go with 0.2mm or less. I used Cura Adaptive Layers so the layer height varied a fair amount depending on the detail needed. I've…
I found the gif of the spinning Nautilus gears to be mesmerizing and I wanted to make it easier to experience that motion. I added the handles and printed the Base Plate and the Stand out of white/gray Marble PLA and the Gears out of…
One of the things I love most about my Sovol Zero is I can grab it and go fairly easily. Mainly I keep it in my office next to my desk but from time to time I want to do a "relatively" large ABS or ASA print so I just carry it out on my…
I printed them in PCTG (my new favorite filament) but PETG would be fine also. PLA probably wouldn't stand up to the dryer's heat.
I'm sealing up my Sovol Zero so as to be able to better print ABS/ASA/etc. I also built a powered chamber exhaust system that pulls air from the exhaust and feeds it to a window vent. By sealing up my print chamber I'm hopefully reducing…
These are all currently available results.
