Counting matching models…
Made a hook with a hole to hang some stuff around the house. it is strong enough to hang a winter coat, i believe it can bear a lot more load but didn't test the max strength. Print settings layer height: 0.12 mm Number of walls: 4…
Work in progress So don't expect this to work as well as a steel bearing. It is a bit of a pain to get the bearing to work after your print is finished. but it will act as a bearing once you finish it. And spins really well. There are…
Remix of the famous drippy bucket, changed de dimensions to make it more suitable for a toothbrush holder, also can be used as small pen container. Original model: https://www.prusaprinters.org/prints/73118-drippy-bucket Print setting…
just reagular print settings for PLA will do fine. for dual color print settings ask me directly.
What a fun challenge, I made several knobs that are easily swapped with one another in case you don't like the previous design/feel anymore. The way it works is that you have a base plate that you attach by either 1 M3 screw or 2 M3…
I used this model to understand the human shoulder in school better. I thought it would help to spread the word to others by uploading this creative commons here. I have not made any changes to this model. I only sized the model down to…
Printing 0.12mm layer height for enough detail 10% infill supports: yes (treelike) brim : yes
Hello! For a project i needed an enclosure for a breadboard and arduino uno. I made it so you can fit on different objects of your liking. with holes on the side! You will need for this project. 4x m3x10 bolt ( you will need to cut them…
Tips: you should not use supports. Because it will likely damage de model. If you use support try treelike supports. this will have the best chance. Or use soluble supports with a multi-material printer. 0.12 mm layer height print at slow…
Really easy to print just use the upright position. with no supports. I printed at 0.3 mm layer height so it would be faster .
Strong modern drawer/cabinet knob Hi there, thank you for your interest in my design. I made this design because I hate it when knobs turn when you grab them and they turn. This design helps with that by using two m3 screw holes. So there…
I had some issues with the middle part snapping off at a party. so I made it a bit stronger. by adding a core to the middle parts, and a fillet where it snapped off. print without supports
I have made 2 versions one with 4 holes and one with 2. part list: 3d printer 4 or 2 10mm diameter x 10 mm length neodymium magnets lighter PLA print settings layer height : 0.3 mm material : PLA infill : 10% supports : no after printing,…
These are all currently available results.
