Counting matching models…
Metal rods for board in cabinet wern´t enough to support weight. So I designed some brackets with to holes to screw them in place. When I uploade the model I realized there were already some similar models so I added this my model as a…
Print with PLA or PETG with 0.25mm or 0.3mm layer height. Place on one side left or right doesn´t matter. Turn on “ Brim ”, otherwise the print might get loosened due to small adhesion surface on print bed. No supports needed. You can…
Printed the first version with PLA. Would advise you too use PETG for outdoor use.
Designed swatches for Spinning Filament Swatch Display - Lifts Swatches from Brad @ FTBT 3D with text for filament type. Following swatches are available. PLA PLA+ PETG ASA PVG FLEX Printing Settings: 0.2mm layer height turn on ironing…
Inspired by Makkuro i made my own design. Simplified and removed some features. Model consists of two parts: Basic filament sample with type of filament on it Name Plate with manufacturer, temperature and name of color on it The name…
For some time I wanted to remove the docking arm of my Bowers and Wilkens Zeppelin Air, because I am not using the old 30pin connector for Ipods. Instead of that I am using Apple Airplay or the AUX connector. If you remove the arm, you…
Always had issues with removing the perlators from the tap to clean them. In the past just used a wrench, but always damaged and scratched them. So I finally decided to design a tool for it and print it. Hope you find it usefull. Print…
Couldn´t replace just the old stopper because of huge hole in cabinet wall, thus I added extra screws and support structure for the holder. Printed with PLA Prusament and 0.2mm layer height.
These are all currently available results.
