Counting matching models…
A simple yet useful headphone/controller stand that can be either mounted using ¼ inch (6.35mm) or smaller screws/bolts OR using a small piece of double-sided tape! Printed using PLA 5% infill 200 degrees 90 mm/sec NO SUPPORTS NEEDED
I made this elbow in order to make a stand for my green screen. It has three available connection points. Good for corner connections or can be used as a t-joint. I made a previous version for a 5/8 inch dowel but it ended up being a bit…
This is a piece needed to connect two dowels in order to complete an overhead camera rig that can be made using the a few 5/8 inch dowels and some 3d printed parts. Here are the rest of the prints you'll need: Device Holder:…
I made this model real quick as i've noticed that I have cables that need to be out of the way when the bed moves. This should do the trick and move them out of the way. You will need a cheap retractable lanyard holder. I got a 5 pack at…
Hello! this is a device holder to hold your phone and is used to make a relatively simple diy overhead camera rig! you can use various methods to secure your phone in place; velcro straps, ¼ adapters, or ¼ bolt and hex nut. Some things to…
Hello! I made this model in order to create an overhead camera rig that I am working on! at the moment, I am still working on other aspects of the rig but I can release these feet to the public. The diameter is designed for a dowel with a…
Clip to add rigidity to the supports on the legs for the camera rig you can find the rest of the stls for the camera rig here: 90 Degree Dowel Connector https://www.printables.com/model/380351-diy-overhead-camera-rig-90-dowel-piece Device…
use this to attach your raspberry pi 4 to the top of your 3d printer.
01/25/2023 update – Initially I made the 25.4 mm legs and had that measurement for everything but then noticed it made contact with the tubes so i extended it to 40 mm. you can still use the 25.4 mm legs, just need the retaining piece so…
These are all currently available results.
