Counting matching models…
Reinforcement plate for the left bottom bracket. The plate is fixed on the inside of the machine chassis and should be used together with the mod “Ender 3 V3 SE KE Gantry support”:…
Filament sensor holder for Ender V3 KE/SE. This mod is required if you are going to move the filament spool to the side of the printer. No supports required. Check also the filament guide mod: h…
Print it with precision settings with layer height as small as possible. My print: Layer height: 0,10mm Infill: 100% Supports/brim: no
Same as the original, just the screw config has been changed
Spot welder station intended to ease the use of those cheap spot welders. Material required Probe Bracket: 2x M3x20 machine screws (hold the 2 half brackets together) 2x M3 nuts (hold the 2 half brackets together) 1 or 2 M3x25 machine…
This part goes under the dial wheel and keeps it connected to the flash body. Print with supports and precision settings with low layer height.
These are all currently available results.
