Counting matching models…
This is half of a pulley wheel for a bicycle chain. Print two and glue together . I found printing the whole wheel required supports that left a surface too unfinished for the need. Fifth photo shows the two halves at the bottom, a glued…
Remix from "SRAM GX EAGLE Pulley wheel" - I found the teeth to be too wide, wouldn't fit the chain. Also I found issues with printing support…the teeth were not smooth enough after removing the supports. So this is HALF of a pulley wheel.…
Tool to help hang pictures on the wall. Similar to the “Go Hang It!”, which can be found on Amazon. If you have a printer larger than the MINI, you might be best served by printing the original. (This one might be too short for handing…
This pin fits in the locking hole in Rivian's R1S Adjustable Cargo Tie-Down . To unlock, push the same button used to slide/remove the tie-down from the track. Printed in PLA (PETG may be better) with 0.20 mm layer height. I printed 4…
These are all currently available results.
