Counting matching models…
This will keep your Speed Editor dust free and protected when sitting on your desktop, or if you want to toss it in a bag for travel. The tall version is a one piece print that's the height of the jog wheel. The thin version is a two…
My Black Diamond headlamp had a bracket with two fingers that let the tilt adjustment click into place. The fingers broke off and the light would flop down. I used scotch tape to hold the angle for a couple years. Then I printed a TPU…
Print 2 of the grid parts from opaque material. Print 2 end panels and 1 center panel from translucent material. The two grid parts are connected with the center panel, then the end panels go on either end. This assembly sits down on the…
Some prototypes which use these blocks: Simple clamp-on blocks with minimal unsupported pockets. Finger press fit of 1.125 inch diameter bearings. Shown with 24 tooth belt pulleys
This mini ratchet is sold by Topeak and O'Reilly Auto (branded Power Torque). This 5 hex bit holder is printed from TPU and clips onto the handle of the ratchet. If you use short bits, two holders with a total of 10 bits clip onto the…
Use these parts to mount an esp32 microcontroller board to a SATA powered aRGB hub to make a multichannel aRGB controller. First drill two 3mm holes 20mm from the ends of the hub circuit board. Use a sharp knife to break the board traces…
These two parts are used to mount a 40mm USB fan to cool a Sony A7IV camera. Assembly instructions in this video: These are printed from TPU .15mm layer height.
These were remixed from another model, but I don't know where it came from. Includes a removable TPU “grommet” for focusing the camera lens. Cases have slots for ventilation, so the camera doesn't overheat.
This is a sleeve style protective case for your ES15 screwdriver. The bits and the ES15 are held in the case with friction. First do a test print of just the end portion, to test the fit of the bits and the screwdriver into the case. This…
There are two versions here, one slightly tighter fit on the hex bits. Use the nose test print to select which one works best with your printer and filament. The covertex wheel and belt clip can be purchased from multiple online shops…
If you run cables and tubes through rev robotics maxtube. This part will protect from damage. Print from TPU. Install with rubber compatible superglue. Can slice with nippers or a blade to install around existing wires and tubing.
Print these standing up with no supports and 4 perimeters of brim. I used PETG to better handle hot temps on the roof. There is a RH and LH version because the bulb sockets are located differently on the two sides. The LED panels are from…
This is a holder for the Radiomaster Zorro controller. It is mounted to the Triple Helix driver's station. The spacers are held by ¼-20 button head cap screws.
Two different styles of 120mm fan grills made with 3D printed frame parts and 1/16" diameter brass rod/wire. There are outer fan frames that mount to the hole pattern for mounting a 140mm fan. The round inserts have holes for the 1/16"…
Use the ends to trim your nickel strips and use the holes to make sharpie marks.
These are all currently available results.
