Counting matching models…
This is a build plate aligner for Neptune 4 Plus. Installs in the rear left corner of the bed. Allows attachment of cable chain parts to the bed cable (optional). Uses the original screws. Unscrew and remove the cable retainer plate,…
Update 2024.06.19: Added a variant that can fit several models of accelerometer: BTT S2DW 1.0 (tested) BTT ADXL345 v2.0 (tested) Mellow Fly-ADXL345-USB (untested; should be OK in REV6) GY-291 / SparkFun ADXL345 (SPI) (tested) GY-521…
If your X + hotend cable flows pretty well and you don't see a need for a cable chain, but just need the cable to route downward instead of outward to save on space or prevent interference, you can use this clip. Tested on Neptune 4 Plus.…
This is a remix of the V-Slot snap in cover created by @jodoll . The slot clip part has been reinforced and thickened. Cover will print with 3x0.4mm or 2x0.6mm walls on the clip portion when printed flat on the bed. Print as oriented with…
On some Neptune 4 Pros I've been fixing I've found that no matter what adjustment I make, the bed POM wheels (and thus the bed) are very loose. I've found that the rails have been pulled inward and need spaced out. At first I made a laser…
This is a cable guide / bracket / clip thing inspired by the stock Elegoo part. Maybe the stock arrangement works for you, but you broke a clip or lost the entire part. No worries - just print one of these out and you'll be good to go.…
I couldn't find a model for the 2mm IDC connector strain relief as used with Neptune 4 Plus hotend assembly, so I created this one measured from the broken pieces I had on hand. May fit other 2mm IDC connectors. Print with a well tuned…
If your Neptune 4 filament runout sensor stud is broken, you can replace it with this piece. Requires an M3 heat set insert. This does not replace the innermost plastic piece, just the metal stud holding piece. I don't know if this…
I doubt anyone else will need this but there's a chance. This is the part of the stock X gantry that the belt attaches to. I received a printer in pieces that was missing this part, so I created it roughly following the original shape.…
These are all currently available results.
