Counting matching models…
This is a CASE for a EMS interface board V3 and a ESP32 LOLIN32 Lite board. EMS interface board V3 ESP32 LOLIN32 Lite board The EMS-ESP github page is here I added the 3mf Prusa Slicer project files because of the honeycomb pattern trick…
The origin is from @Maxim7745_280394 This is a test print to help fine tune a printer nozzle's Z offset. It prints squares that range from -0.05 mm to +0.05 mm in height. See picture for the square layout. All gcode files are meant for…
The Senosor became too hot on the first model despite the honeycomb on the lid. For this reason, I also had to design the outer wall with honeycomb. Now there is no heat problem in the housing and the sensor measures the content of CO2 in…
This is a air quality lamp for CO2 metering. I used the design from Lilifee (look at the remix). The original was for the BME680 Sensor. I needed the case for the MH-Z19. So I changed the inner of the case and the "Top"-part. The…
We lost the foot on our camping chair. That would't be so bad if not always dirt come into the aluminumprofile, that then lands in the Camper. In addition, the aluminum cuts our camping carpet. So I decided to draw a foot for the chair.…
These are all currently available results.
