Air quality lamp for CO2 metering (MH-Z19, esp32 and neopixel) with honeycombshell
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€0.38 – €0.47 net (excluding VAT)
For file: TOP_0.2mm_PETG_MK3S_27m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.43 excluding VAT (range midpoint).
- Weight reported by the author
- 5 g
- Print time reported by the author
- 27.6 min
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
This is a Remix of the Air quality lamp for CO2 metering (MH-Z19, esp32 and neopixel)
- Rating
- 3 / 5
- Likes
- 40
- Downloads
- 158
- Makes
- 1
- Views
- 1,601
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
The Senosor became too hot on the first model despite the honeycomb on the lid. For this reason, I also had to design the outer wall with honeycomb. Now there is no heat problem in the housing and the sensor measures the content of CO2 in the air without problems.
I added the "3mf"-file because I still use the infill trick (look at the blog post her) for the top side of the lid. The Prusa Slicer produces a more uniform honeycomb. I used the honeycomb infill with 30%.