Air quality lamp for CO2 metering (MH-Z19, esp32 and neopixel) with honeycombshell
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Wstępna wycena dla PETG
0,38 € – 0,47 € netto (bez VAT)
Dla pliku: TOP_0.2mm_PETG_MK3S_27m.gcode
To wstępna wycena jednego pliku. Dokładną cenę poznasz przed zamówieniem.
Plik i założenia wyceny
Plik użyty do wyceny
Średnia wycena orientacyjna: 0,43 € netto (środek widełek).
- Masa podana przez autora
- 5 g
- Czas druku podany przez autora
- 27,6 min
- Materiał u źródła
- PET
- Materiał wyceny
- PETG
- Drukarka wyceny
- Bambu Lab P1S - 0.4 nozzle
- Proces wyceny
- 0.20mm Standard
Orientacyjna wycena wyłącznie wybranego pliku, oparta na masie i czasie druku podanych przez autora. Warianty plików nie są sumowane. Ostateczna cena zostanie obliczona po analizie pliku.
Zapisane na tym urządzeniu.
This is a Remix of the Air quality lamp for CO2 metering (MH-Z19, esp32 and neopixel)
- Ocena
- 3 / 5
- Polubienia
- 40
- Pobrania
- 157
- Wydruki
- 1
- Wyświetlenia
- 1595
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
The Senosor became too hot on the first model despite the honeycomb on the lid. For this reason, I also had to design the outer wall with honeycomb. Now there is no heat problem in the housing and the sensor measures the content of CO2 in the air without problems.
I added the "3mf"-file because I still use the infill trick (look at the blog post her) for the top side of the lid. The Prusa Slicer produces a more uniform honeycomb. I used the honeycomb infill with 30%.