Counting matching models…
I made some minor changes to the original Percussion caps, these are a little longer, and a tiny bit smaller in diameter and are also designed with 2 walls vs the 1 wall of the original. These will fit a bit tighter onto a #10 Percussion…
You will require to print 2 of these and then glue them together (with your favorite type of glue, I used an epoxy style glue). It is recommended to off set the 2 pieces on the mounting holes so that you can utilize all of the mounting…
This is a little kit I assembled for filling multiple Prime-all Percussion caps with a little more ease. it includes a percussion cap holder that locks caps into place, a funnel, and a tamper for the prime-all. As always, there might be a…
These are #10 percussion cap shells, will need to load these with a primer compound. This will print a set of 25 caps, the printer settings, best to use a speed 30 mm/s and on a raft for adhesion to the printer. Print them out, allow to…
An improved version of the older Cap holder and funnel system. the funnel will require some post processing. I used 1000 Grit sand paper on the inside of the funnel to make it easier to fill the caps.
A simple 12 piece shell holder for the #10 Percussion caps found on this profile. To ease in loading these primer caps.
This is a simple funnel for use with my percussion caps on my profile. You will need to use supports, and there will be some post processing. The caps will fit inside of the funnel to better facilitate loading the primer material.
These are all currently available results.
