Counting matching models…
I liked the concept of Maff's Hadley telescope , but the design of the seemed a bit clunky. I started from scratch and re-designed every part to use metric screws, threaded inserts, and a cleaner, more cohesive design language. Read…
This model is designed to mount on a 3mm panel and comes in three angles relative to the panel 0°, 30°, and 45°. The mounting pattern is an equilateral triangle with sides of 26mm. You will need to drill three 3mm (or 1/8") holes and one…
This model was designed to mount the ERCF on top of a Voron 2.4 or Trident printer. It consists of three identical arms, and a bottom plate that moves the mounting hole locations, and provides a place to attach an EasyBrd. The top arms…
This model is split into two pieces for easier printing. After printing, the small back piece should be glued into the recess. The finished grip is held in place with a M3x8 screw.
These models modify the base Hadley Neumo bodies to add magnet pockets. This allows you to attach magnetic covers and filters. It also includes magnetic accessory mounts (4 magnet and 2 magnet) to easily attach sights, or any other…
This model locks the arm rests to one position of your choosing by replacing the indexing component inside the arm rest with a fixed piece. There are 11 plate options labeled -5 to +5. The more negative a number, the further outwards the…
This model will allow you to mount your EasyBrd underneath the body of your ERCF. This retains the original mounting hole pattern. When the ERCF isn't mounted, the heat sinks will stick up past the feet. Be careful not to knock these off.…
This is a rebuilt version of wigglememore's Hadley 1.25" Focuser Options to attach to the telescope body using M5x12 screws. This remix is intended to be used with the Hadley Neumo telescope The model is already oriented to print without…
This model consists of two parts: light shrouds and connector rings. The connector rings connects the telescope bodies with the light shroud and seals the connection to prevent any light leaks. The light shrouds can be installed with very…
The model is already oriented to print without supports. You will need to press fit three 3x6mm magnets into the flat side.
This model allows you to attach any camera with a Fujifilm X series lens connector to a 1.25" telescope. The telescope side and camera side are separated for easier printing and attached together by M3x8 screws. There are three versions…
How do you measure your butter after it's been unwrapped? This butter ruler is marked with teaspoon, tablespoon, and 1/8 cup increments and comes in three versions: no handle, right handed, and left handed. **Designed for the stick of…
This is designed for the 6th generation Outback (2020 - 2024…) and fits inside the stock cup holder spacer (part number: 92076AN00A) in case you need to use the deep cupholder. **The model is oriented to print without support.
This model will hold 12 glass vials with a diameter of 16mm either upright or upside-down for drying. If you print multiple, they will fit together end to end. These are the vials I used bought ( Link ). The listing shows them as 17mm,…
These are all currently available results.
